A TLS config was being assigned to a Transport in a nil http.Client. The
Transport is built in the consul config by default, but the http.Client
is not built until later in NewClient.
Updated the vendored consul which no longer requires the channel adapter
to convert a `chan stuct{}` to a `<-chan struct{}`.
Call testutil.NewTestServerConfigT with the new signature.
When a consul lock is lost, there is a possibility that the associated
session is still active. Most commonly, the long request to watch the
lock key may error out, while the session is continually refreshed at a
rate of TTL/2.
First have the lock monitor retry the lock internally for at least 10
seconds (5 attempts with the default 2 second wait time). In most cases
this will reconnect on the first try, keeping the lock channel open.
If the consul lock can't recover itself, then cancel the session as soon
as possible (terminating the PreiodicRenew will call Session.Destroy),
and start over. In the worse case, the consul agents were split, and the
session still exists on the leader so we may need to wait for the old
session TTL, plus the LockWait time to renew the lock.
We use a Context for the cancellation channels here, because that
removes the need to worry about double-closes and nil channels. It
requires an awkward adapter goroutine for now to convert the Done()
`<-chan` to a `chan` for PeriodicRenew, but makes the rest of the code
safer in the long run.
Consul locks are based on liveness, and may be lost due timeouts,
network issued, etc. If the client determines the lock was lost, attempt
to reacquire the lock immediately.
The client was also not using the `lock` config option. Disable locks if
that is not set.
This matches the consul cli behavior, where locks are cleaned up after
use.
Return an error from re-locking the state. This isn't required by the
Locker interface, but it's an added sanity check for state operations.
What was incorrect here was returning an empty ID and error, which would
indicate that Lock/Unlock isn't supported.
This adds a "lock" config (default true) to allow users to optionally
disable state locking with Consul. This is necessary if the token given
doesn't have session permission and is necessary for backwards
compatibility.
Gove LockInfo a Marshal method for easy serialization, and a String
method for more readable output.
Have the state.Locker implementations use LockError when possible to
return LockInfo and an error.
Use consul locks to implement state locking. The lock path is state path
+ "/.lock" which matches the consul cli default for locks. Lockinfo is
stored at path + "/.lockinfo".
Minkyu Kim